Avery-dennison 6054 Network Control Module Manual de usuario descargar pdf

6054 Network

Control Module

6055 Docking Modules

OPERATING INSTRUCTIONS

Use these Operating Instructions to assemble and use

the 6054 Network Control Module and the 6055 Docking

Module.

The 6054 Network Control Module controls one to four

6055 Docking Modules, which provides Pathfinder® 6057

printer charging and Ethernet communication capability

The 6054 Network Control Module and the 6055 Docking

Module can only be used with printers that contain the

approved battery as listed in the printer documentation.

Refer to the Operator’s Handbook for additional important

battery safety information.

Follow the operating and storage limit specifications

listed at the end of these instructions. Otherwise, the

battery may permanently lose its charge capacity.

Note: You must charge the printer before using it.

1 2 3 4 5 6 7 8

2 Assembling the Network Control Module 1. Turn over the 6055 Docking Module and 6054 Network Control Module. 2. Using a Philips screwdriver, remove

3 4. Loosen the two screws on the 6054 Network Control Module and slide the 6054 Network Control Module onto the Docking Module’s connector plate. T

4 Setting up the Network Control Module 1. Plug the supplied power cable into the Network Control Module. 2. Plug the other end of the cable into a

5 Reading the Ethernet LEDs When the communication port is connected, two LEDs indicate the following: LED ON OFF Blinking Yellow Full Duplex Mode

6 The green power LED on the 6054 Network Control Module turns on when there is power to it. Charging time can take up to three hours. It takes appro

7 Specifications Operating Limits: Temperature 32°F to 104°F (0°C to 40°C) Humidity 5% to 90% non-condensing Storage Limits: Temperature -40°F to 1

Modelos relacionados 6055 Docking Module

Sin comentarios