Avery Dennison LOKPRINT 676 Manual de usuario Pagina 17
- Pagina / 51
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Users Manual LOKPRINT™ II LOKPRINT™ II Operation / Adjustments •
••
• 17
SNAP ON COVER
VAPOR FILTER
Ventilation
The LOKPRINT™ II is equipped with a ventilation system comprising of two fans
with carbon filters and multiple internal machine compartments / components. One
filter is used to reduce the odors that are exhausted from the heat chamber while the
other is used to filter the ambient air drawn in to cool the electronics compartment.
Vapors created during the sublimation process have an odor and may be seen as
smoke escaping from the heat chamber area. If there is an unusually high amount of
odor or visual smoke escaping near the front of the machine - check the filter(s) on
the back of the machine. Make sure they are in place and clean. The filters are held
in place with a snap on cover for quick and easy replacement.
The exhaust fan’s filter (on the right as viewed from the rear of the machine) will
normally need to be turned over after every 2 rolls of ink and replaced after
approximately 4 rolls of ink. At the time of replacement it is recommended to move
the intake fan’s filter to the exhaust fan and install a new filter on the intake fan. This
rotation procedure will insure that both filters are kept at peak performance.
As the system pulls fresh air in the front of the heat chamber and exhausts it out the
filter - it also cools the outer surfaces of the machine so they are safe to the touch.
These surfaces will be warm to the touch, but will not cause burns.
It is extremely important to keep the Plexiglas guard closed at all times during
operation except for threading the fabric. The airflow management and heat chamber
control systems have both been designed to operate with the guard closed and all the
covers in place. Attempting to operate the system with any guard or cover altered or
missing will disrupt the control strategies and adversely affect the fabric temperature.
- LOKPRINT 1
- Contents 3
- Safety Issues / Warnings 5
- Warranty Information 6
- Service 7
- AC Power Line 8
- Branch Circuit Protection 9
- Unpacking / Inventory 10
- Inventory of Components 11
- Recommended Spare Parts 11
- LOKPRINT™ II Assembly 12
- Installing the Power Cord 13
- Product Description 14
- LOKPRINT™ II Specification 15
- Adjustments 16
- LOKPRINT™ II Operation / 16
- Ventilation 17
- Web Threading 18
- Heat Chamber Care 19
- Feed Roller Care 19
- Lamp Replacement Procedure 20
- Drive Cable Replacement 22
- Procedure 22
- Troubleshooting 23
- Electrical Schematic 27
- 115 / 230 Volt Schematic 28
- Mechanical Assembly Drawings 29
- Cover Assembly 30
- Cover Parts List 31
- Baffle Assembly 32
- Baffle Parts List 33
- Air Filter Assembly 34
- Air Filter Parts List 35
- Web Guide Assembly 36
- Web Guide Parts List 37
- Drive Assembly 38
- Drive Parts List 39
- Feed Assembly 40
- Feed Parts List 41
- Controller Assembly 42
- Controller Parts List 43
- Heat Chamber Assembly 44
- Heat Chamber Parts List 45
- Slide Mechanism Assembly 46
- Slide Mechanism Parts List 47
- Cable Routing Diagram 48
- Home Sensor Assembly 50
- Home Sensor Parts List 51
Relacionado con productos y manuales para Impresión y escaneo Avery Dennison LOKPRINT 676
(93 paginas)Hypercel 12181 manuals
Owner’s manuals and user’s guides for Power suppliers Hypercel 12181.
We providing 1 pdf manuals Hypercel 12181 for download free by document types: User Manual
Comentarios a estos manuales