Avery Dennison Monarch 9433 SNP Especificaciones descargar pdf (Pagina 12)

2-2 System Administrator’s Guide

Before You Begin

Configure your computer to communicate on a wireless network before you

continue.

 To connect a device using an access point, set your computer to

infrastructure mode.

 To connect directly to a device without an access point, set your

computer to Ad-Hoc Computer-to-Computer mode, or whatever mode your

adapter uses to communicate without an access point.

 To use Ad-Hoc mode, temporarily disable security on your access point.

After the print server is configured, re-enable security on the access

point.

 To use WEP (Wired Equivalent Privacy) encryption or other advanced

security, such as WPA (Wi-Fi Protected Access), on your wireless

network, temporarily disable the security on your computer in order to

configure the print server. To allow non-secure clients to communicate

with each other, temporarily change the wireless mode of your computer

to Ad-Hoc mode.

 To use TCP/IP, note your computer’s IP address. The print server needs

to be on the same IP segment as the other nodes on your network in

order to communicate.

 You need a good signal between your computer and the access point to

communicate.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 103 104

Sin comentarios

Avery Dennison Monarch 9433 SNP Especificaciones Pagina 12